20 to +100☌ -4☏ to +212☏ (no freezing/condensation) *3ġ0-30 VDC, Ripple (P-P): 10% max, Class 2 or LPSĥ0 mA or less (when 24 V: 32 mA or less, when 12 V: 48 mA or less. G3/4 (Changes to the R male 1/8, R male 1/4, R male 3/8, G female 1/4, NPT male 1/8, and NPT male 1/4 option adapters are available.) Liquid that will not corrode the liquid contact part Gas or liquid that will not corrode the liquid contact part *8 See '7' in 'Other precautions' on P.13 for measures on preventing condensation. *7 IO-Link specification v1.1/COM2 (38.4 kbps) is supported. *6 This is the value when the measured fluid is water and a KEYENCE adapter is used. *5 Consumption current including output is 0.3 A and under. Keep the sensor 30 cm 11.81' or more from the cooling pipe using connective piping.Make sure the ambient temperature is the same or lower than the fluid temperature.To prevent condensation, take the following measures: *4 Condensation may cause measurement failure or breakage. *3 When the temperature of the piping exceeds 80☌ 176☏, do not connect the cable.

*2 The repeatability, based on consistent conditions, is the difference in the detection points at the time of fluctuations in the repetition. *1 This is the value when considering linearity + hysteresis + repeatability in a stable environment of 23☌ 73.4☏. Housing metal portion: SUS304, SUS303 Housing plastic portion: PPSU Air hole *9: PTFE, nickel-plated brass. Pressure port: SUSXM7/Diaphragm pressure port: Al 2O 3/O-Ring: FKM IEC6 50 G (11 ms In each direction X, Y, Z 3 times) IEC6 20 G (10 to 2000 Hz In each direction of X, Y, Z for 2 hours) Pressure analog output/temperature analog output (selectable), 4–20 mA maximum load resistance 260 Ω 100 mA Residual voltage for the Main Unit is 1 V or less, N.O./N.C. NPN/PNP open collector (Selectable) 30 V or less, Status indicator (orange, green, red, blue), output indicator 1 (orange), output indicator 2 (orange), temperature indicator (white), communication indicator (green)ĭuring hysteresis mode: variable (Hysteresis is the difference between the upper setting value and the lower setting value) Liquid contact temperature measurement accuracy Excluding output) *5Ĥ column digital LED white/Vertical inversion of display is possible –20 to +100☌ –4 to +212☏ (no freezing/condensation) *3 *4ġ0 to 30 VDC, Ripple (P-P): 10% max., Class 2 or LPSĦ0 mA or less (when 24 V: 30 mA or less when 12 V: 50 mA or less. G3/4 (Changes to R1/8 male, R1/4 male, R3/8 male, G1/4 female, NPT1/8 male, and NPT1/4 male with available adapters.) Liquid that will not corrode the fluid contact part Gas or liquid that will not corrode the fluid contact part Industrial Continuous Inkjet Printers / CIJ Printers.LVDT / Contact Displacement Sensors (Probes).Spectral Interference Displacement Sensor.

1mpa to psi